HOW TO MAKE AND RESTORE GHOST FILE  by Norton Ghost Image

You can restore a ghost file through ghost software installed on bootable pen drive.To make a bootable pen drive you need a pen drive formatting software with system files. Therefore you need the following files (a) IBM.BIO (System Files) (b) IBM.DOS (System Files) (c) COMMAND.com (for booting from pen drive) (d) MOUSE.com  (for Mouse operation) (e) MOUSE.ini  (Mouse configuration file) (f) GHOST.EXE (Ghost software) To download the pen drive formatting software (ghost 11.5 bootable usb) from internet click on the following link:-http://download2388.mediafire.com/8pzcha70vozg/5c96mceeplyvwhn/Format+USB.r http://download2389.mediafire.com/5bka3d70e5tg/42914n0asj6bdx6/Usboot+Norto Download Format USB directly http://www.mediafire.com/download/5c9… Download Usboot Norton Ghost directly http://www.mediafire.com/download/429…

Click to access ghost%20file.pdf

Method:- Step-1:- download both files (a) Format USB (b) Usboot Norton Ghost Both files are compressed therefore first of all decompressed both files on you PC Step-2:- Prepair pen drive Use command DISKPART

  • DISKPART
  • insert your pen drive on your PC  usb port (b) Run (CMD) ommand as an administrator TYPE DISKPART Then Press ENTER
  • C:\ C:\DISKPART> you will get this prompt Now
  • USE FOLLOWING COMMANDS
  • LIST DISK
  • SELECT DISK 1
  • CLEAN
  • CREAT PARTITION PRIMARY
  • SELECT PARTITION 1
  • FORMAT FS=NTFS QUICK ACTIVE
  • (c) Run Format Tool from USB uncompressed file folder as an administrator
  • See in DEVICE your Pen Drive will be there
  • File system Select FAT32
  • Tick Mark on Format Device
  • Tick Mark on Cerate a DOS startup disk
  • (d) Usboot Norton Ghost uncompressed file folder and
  • (e) select BOOT folder  then
  • (f) click Start
  • (g) After formatting usb drive go to Usboot Norton Ghost uncompressed file folder select all files copy and then  paste in usb drive.
  • Now your PEN DRIVE is ready to use.
  • CHECK BOOTING FROM PEN DRIVE
  • Reboot your Computer at startup press F12 and select booting from USB then press Enter
  • Now your Computer will boot from Pen Drive with ghost programme starting Menu
  • Click on OK
  • The End 

Thanks

Adeeb Raza

About adeebraza1236

I am an electronic instrumentation engineer by profession but I am working as a design engineer. I can design electronic hardware interface circuits for computer based security system, Computer based industrial control system for automation and process control Etc. My Interests: Electronics Circuit designing with PCB Designing, Computer software development using VB & C , PC based security system, Designing LED Lights, UPS, Inverter Etc
This entry was posted in Uncategorized. Bookmark the permalink.

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out /  Change )

Twitter picture

You are commenting using your Twitter account. Log Out /  Change )

Facebook photo

You are commenting using your Facebook account. Log Out /  Change )

Connecting to %s